153 lines
4.8 KiB
Plaintext
153 lines
4.8 KiB
Plaintext
config usteer
|
|
# The network interface for inter-AP communication
|
|
option 'network' 'mgmt'
|
|
|
|
# Log messages to syslog (0/1)
|
|
option 'syslog' '1'
|
|
|
|
# Disable network communication (0/1)
|
|
option local_mode '0'
|
|
|
|
# Use IPv6 for remote exchange
|
|
option 'ipv6' '1'
|
|
|
|
# Minimum level of logged messages
|
|
# 0 = fatal
|
|
# 1 = info
|
|
# 2 = verbose
|
|
# 3 = some debug messages
|
|
# 4 = network packet information
|
|
# 5 = all debug messages
|
|
option 'debug_level' '2'
|
|
|
|
# Maximum number of neighbor reports set for a node
|
|
#option max_neighbor_reports 8
|
|
|
|
# Maximum amount of time (ms) a station may be blocked due to policy decisions
|
|
#option sta_block_timeout 30000
|
|
|
|
# Maximum amount of time (ms) a local unconnected station is tracked
|
|
#option local_sta_timeout 120000
|
|
|
|
# Maximum amount of time (ms) a measurement report is stored
|
|
#option measurement_report_timeout 120000
|
|
|
|
# Local station information update interval (ms)
|
|
#option local_sta_update 1000
|
|
|
|
# Maximum number of consecutive times a station may be blocked by policy
|
|
#option max_retry_band 5
|
|
|
|
# Maximum idle time of a station entry (ms) to be considered for policy decisions
|
|
#option seen_policy_timeout 30000
|
|
|
|
# Minimum number of stations delta between APs before load balancing policy is active
|
|
#option load_balancing_threshold 5
|
|
|
|
# Minimum number of stations delta between bands before band steering policy is active
|
|
#option band_steering_threshold 5
|
|
|
|
# Interval (ms) between sending state updates to other APs
|
|
#option remote_update_interval 1000
|
|
|
|
# Number of remote update intervals after which a remote-node is deleted
|
|
#option remote_node_timeout 10
|
|
|
|
# Allow rejecting assoc requests for steering purposes (0/1)
|
|
#option assoc_steering 0
|
|
|
|
# Minimum signal-to-noise ratio or signal level (dBm) to allow connections
|
|
#option min_connect_snr 0
|
|
|
|
# Minimum signal-to-noise ratio or signal level (dBm) to remain connected
|
|
option min_snr -89
|
|
|
|
# Timeout after which a station with snr < min_snr will be kicked
|
|
#option min_snr_kick_delay 5000
|
|
|
|
# Timeout (ms) for which a client will not be steered after rejecting a BSS-transition-request
|
|
#option steer_reject_timeout 60000
|
|
|
|
# Timeout (in ms) after which a association following a disassociation is not seen
|
|
# as a roam
|
|
#option roam_process_timeout 5000
|
|
|
|
# Minimum signal-to-noise ratio or signal level (dBm) before attempting to trigger
|
|
# client scans for roaming
|
|
option roam_scan_snr -73
|
|
|
|
# Maximum number of client roaming scan trigger attempts
|
|
#option roam_scan_tries 3
|
|
|
|
# Retry scanning when roam_scan_tries is exceeded after this timeout (in ms)
|
|
# In case this option is set to 0, the client is kicked instead
|
|
#option roam_scan_timeout 0
|
|
|
|
# Minimum time (ms) between client roaming scan trigger attempts
|
|
#option roam_scan_interval 10000
|
|
|
|
# Minimum signal-to-noise ratio or signal level (dBm) before attempting to trigger
|
|
# forced client roaming
|
|
option roam_trigger_snr -75
|
|
|
|
# Minimum time (ms) between client roaming trigger attempts
|
|
#option roam_trigger_interval 60000
|
|
|
|
# Timeout (ms) for client roam requests. usteer will kick the client after this times out.
|
|
#option roam_kick_delay 10000
|
|
|
|
# Minimum signal strength difference until AP steering policy is active
|
|
#option signal_diff_threshold 0
|
|
|
|
# Initial delay (ms) before responding to probe requests (to allow other APs to see packets as well)
|
|
#option initial_connect_delay 0
|
|
|
|
# Enable kicking client on excessive channel load (0/1)
|
|
#option load_kick_enabled 0
|
|
|
|
# Minimum channel load (%) before kicking clients
|
|
#option load_kick_threshold 75
|
|
|
|
# Minimum amount of time (ms) that channel load is above threshold before starting to kick clients
|
|
#option load_kick_delay 10000
|
|
|
|
# Minimum number of connected clients before kicking based on channel load
|
|
#option load_kick_min_clients 10
|
|
|
|
# Reason code on client kick based on channel load (default: WLAN_REASON_DISASSOC_AP_BUSY)
|
|
#option load_kick_reason_code 5
|
|
|
|
# Attempting to steer clients to a higher frequency-band every n ms.
|
|
# A value of 0 disabled band-steering.
|
|
#option band_steering_interval 120000
|
|
|
|
# Minimal SNR or absolute signal a device has to maintain over band_steering_interval to be
|
|
# steered to a higher frequency band
|
|
option band_steering_min_snr -69
|
|
|
|
# Interval (ms) the device is sent a link-measurement request to help assess
|
|
# the bi-directional link quality. Setting the interval to 0 disables link-measurements.
|
|
#option link_measurement_interval 30000
|
|
|
|
# Script to run after bringing up a node
|
|
#option node_up_script ''
|
|
|
|
# Message types to include in log
|
|
# Available types:
|
|
# - probe_req_accept
|
|
# - probe_req_deny
|
|
# - auth_req_accept
|
|
# - auth_req_deny
|
|
# - assoc_req_accept
|
|
# - assoc_req_deny
|
|
# - load_kick_trigger
|
|
# - load_kick_reset
|
|
# - load_kick_min_clients
|
|
# - load_kick_no_client
|
|
# - load_kick_client
|
|
# - signal_kick
|
|
#list event_log_types ''
|
|
|
|
# List of SSIDs to enable steering on
|
|
list ssid_list 'OpenFest2023'
|